VCS VIP 10 Guia do Utilizador descarregar pdf (Página 105)

VIP 10 105

Maintenance and Upgrades 12

Testing the network connection

The ping command can be used to check the connection between two IP

addresses. This allows you to test whether a unit is active in the network.

– Open the DOS command prompt.

–Type ping followed by the IP address of the unit.

If the unit is found, the response appears as Reply from ..., followed by the

number of bytes sent and the transmission time in milliseconds. Any other

response indicates that the unit cannot be accessed via the network. Possible

causes:

] The unit is not properly connected to the network. Check the cable

connections in this case.

] The unit is not correctly integrated into the network. Check the IP address,

subnet mask and, if necessary, the gateway IP.

Device reset

The reset button can be used to reset the unit to its original factory settings. Any

changes in the settings will be overwritten by the factory defaults. This may be

necessary, for example, if the unit has invalid settings that prevent it from

functioning as desired.

Warning!

All configured settings will be discarded during a reset. If necessary, back

up the current settings using the Download button on the configuration

page entitled Firmware and configuration upload (see page 66 for

sender and page 83 for receiver).

Before starting the firmware update, be sure that you have selected the

correct upload file! Uploading the wrong files can result in the unit no longer

being addressable, requiring it to be replaced. Do not interrupt the firmware

installation for any reason! Interruption will damage the Flash EPROM. This

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 121 122

Sem comentários

VCS VIP 10 Guia do Utilizador Página 105