VCS VIP 10 Guia do Utilizador descarregar pdf (Página 22)

Installation Chapter 4

22 VIP 10

] Enter only one command at a time.

] After entering a value (such as an IP address), re-check the entry before

pressing the Enter key to send the data to the VIP.

Assigning an IP address

To operate the VIP on your network, you must assign it an IP address that is

recognized by the network.

The following default address has been pre-set at the factory:

Sender: 192.168.0.1

Receiver: 192.168.0.2

– Start up a terminal program such as HyperTerminal.

– Enter service as user name and password. The main menu will be

displayed.

– Enter i to open the IP menu.

– Enter i once more. The current IP address will be displayed, and you will be

requested to enter a new IP address.

– Enter the desired IP address and press [ENTER]. The new IP address will be

displayed.

– If necessary, enter s and a new subnet mask.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 121 122

Sem comentários

VCS VIP 10 Guia do Utilizador Página 22