VCS VIP 1000 Guia do Utilizador descarregar pdf (Página 21)

Chapter 4 Installation

VIP 1000 21

Network

You can connect the VIP to a 10/100 Base-T network. Use a standard UTP

Category 5 cable with RJ45 connectors for this.

– Connect the unit to the network using the Ethernet jack.

Alarm inputs

The VIP has two alarm inputs on the orange terminal block. The alarm inputs are

used to transfer signals from external alarm devices, such as door contacts or

sensors. Given the appropriate configuration, an alarm device can, for example,

trigger automatic connection between the VIP and a remote location. A voltage

free normally open contact or switch can be used as an actuator (for pin

assignment see page 116).

Note

It is preferable to use an actuator with a bounce-free contact system.

– Connect the leads to the appropriate terminals on the orange terminal block

and check that the connection is secure.

Relay output

The VIP has a relay output for switching external devices, such as lights or

audible alarms. This relay output can be activated manually if there is an active

connection with the VIP. Moreover, the output can be configured to activate

audible alarms or other devices as a response to an alarm signal. The relay

output is also located on the orange terminal block (for pin assignment see

page 116).

Warning!

The maximum rating of the relay contact is 30 V and 1 A.

– Connect the leads to the appropriate terminals on the orange terminal block

and check that the connection is secure.

Microphone/loudspeaker

The connection for the microphone/loudspeaker is also on the orange terminal

block (for pin assignment see page 116).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 125 126

Sem comentários

VCS VIP 1000 Guia do Utilizador Página 21