VCS VIP 1000 Guia do Utilizador descarregar pdf (Página 81)

Chapter 7 Configuring the Receiver

VIP 1000 81

Note

If the VIP connects to a "dual streaming“ encoder Stream 1 will be

transmitted.

Number of destination IP address:

Here you assign the numbering for the IP addresses to be contacted in the event

of an alarm. The unit contacts the remote locations one after the other in the

numbered sequence until a connection has been established.

Destination IP address:

For each number, enter the corresponding IP address of the desired remote unit.

Destination password:

Enter the password, if the remote unit is protected by a password.

Remote encoder line:

If the remote unit is a multi-channel device enter here the number of the video

input which is to be the data source.

Auto-connect:

Select On if an active connection should be reestablished automatically to one of

the previously specified IP addresses after each restart, e.g. after a connection

breakdown or network dropout.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 125 126

Sem comentários

VCS VIP 1000 Guia do Utilizador Página 81